Milling fixture for two part variants

A fixture for machining two variants of an 80 kg part. Interchangeable top plates fit a common base, and the part can be slid into place without lifting it.

Milling fixture for two part variants

Brief

Design a milling fixture for two part variants. The 80 kg part had to slide into the fixture without being lifted.

Scope

The work covered the design and manufacture of a fixture with a common base plate and a top plate for each part variant.

Engineering solution

The base plate uses a pneumatic loading system. A combined Harting connector carries the pneumatic connections and control signals. Each top plate has its own connector and the common base has a connection for both variants. Low-friction plastic segments locate the part and the front segment folds down for loading. Three suction cups secure the centred part, and a sensor checks that it is loaded in the correct orientation.

Project status

The case study dated 31 March 2025 shows the fixture being set up and tested before acceptance. The acceptance outcome and current operating status are outside the scope of the record.

I want a similar solution